Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
209
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
15. Engine speed below 500 rpm and turboclutch function
switched off
Indication accompanied by intermittent audible signal and warning lamp.
Cause Remedial Action
Engine speed too low. Increase engine speed.
16. Front /rear PTO overspeed
Display accompanied by warning light.
Cause Remedial Action
In PTO stage 1000, from 1170 rpm. Reduce PTO speed.
In PTO stage 540E as of 630 rpm. Reduce PTO speed.
In rear PTO 540 setting, from 630 rpm. Reduce PTO speed.
17. Valve prioritisation
Display accompanied by warning light.
Cause Remedial Action
Prioritised valve is requiring more oil than the
pump can provide.
Valve priority is deactivated temporarily until the
pump is able to provide the required quantity
again.
18. Driving mode selector
Indicator goes off after about 3 seconds.
Cause Remedial Action
Range control oil too cold. Repeat operating range selection at oil tempera-
tures above 10°C or shift while at a standstill.
19. Variotronic Ti
Cause
Remedial Action
Engine speed below 400 rpm when playback is
started.
Increase engine speed. Start playback again.