Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
208
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
Fault-module
10. Contaminated air filter
Indication accompanied by intermittent audible signal and warning lamp.
Cause Remedial Action
Air filter main cartridge dirty. Check air filter main cartridge. If necessary, clean
or replace the air filter main cartridge.
11. Instrument cluster memory
Display accompanied by a continuous beep and warning light.
Cause Remedial Action
Invalid programming of combination instrument. Re-programme (at workshop).
12. Hand brake on
Indication accompanied by intermittent audible signal and warning lamp.
Note: only when tractor moving.
Cause Remedial Action
Hand brake applied. Release parking brake.
13. Engine speed too high
Indication accompanied by intermittent audible signal and warning lamp.
Cause Remedial Action
Engine speed too high. Reduce engine speed.
14. Rear PTO on neutral
Display accompanied by warning light.
Cause Remedial Action
PTO speed not preselected. Pre-select PTO speed.