Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
207
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
6. Contaminated transmission oil filter
Display accompanied by warning light.
Note: Change the cartridge as soon as the display appears. The display may go out
again, still change the cartridge.
Cause Remedial Action
Contaminated hydraulic oil filter element. Replace filter unit.
7. Excessive transmission oil temperature (95° - only in range II)
Cause
Remedial Action
Heavy traction work over extended period in
range II.
Switch to driving mode I.
Cooler soiled. Clean the transmission oil cooler.
Turboclutch function active for too long. Increase engine speed (above 1400 rpm).
Clutch pedal depressed for too long. Release clutch pedal.
8. Transmission oil temperature too high (105°)
Cause
Remedial Action
Transmission oil too hot. Allow transmission oil to cool down.
Cooler soiled. Clean the transmission oil cooler.
9. Oil level too low in brake and clutch system
Indication accompanied by intermittent audible signal and warning lamp.
Cause Remedial Action
Oil leakage. Check brake system for leaks. If necessary, fill up
with hydraulic oil (Pentosin CHF 11 S).