Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
158
CARE AND MAINTENANCE
16.3 Replacing the recirculating
air filter
Operation_Pic_number:1
● Dismount air nozzles (right and left) and re-
move filter (A).
Fig.56
17. Air conditioning
Text-module
Switch on the air conditioning once a month
(even in winter) for about 10 minutes, setting the
ventilation to recirculated air mode (see OPERA-
TION Section 3.2).
Clean roof fan filter and recirculating air filter
(see CARE AND MAINTENANCE Section 16).
17.1 Condenser
Operation_Pic_number:1
● If dirty, blow through or spray the condenser
(A) from the inside.
Checking coolant level
Operation_Pic_number:1
● Switch on system. The compressor must also
be running. At an engine speed of 2,000 rpm;
white ball (A) in the sight glass of the fluid tank
must float.
Topping up with coolant or replacing the tank /
dryer can only be undertaken in the workshop.
NOTE:
The blue ball turning pink indicates moisture
in the system.
Fig.57
Fig.58