Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
150
CARE AND MAINTENANCE
Replacing pressure filter
A soiled pressure filter (A) is indicated by a
warning message (see also FAULTS AND
REMEDIAL ACTIONS Section 1.1). Replace the
filter element as soon as possible, but not later
than every 1000 operating hours.
Operation_Pic_number:1
Text-module
● Unscrew the filter housing (A).
● Withdraw the filter element from housing.
● Replace the filter element, do not wash out.
● Lightly oil the sealing rings.
● Put filter housing back in place and tighten
screw (to 40 Nm).
Replacing intake filter
Operation_Pic_number:1
● Remove cover (A) and extract the intake filter.
● Replace the spin-oil filter.
Fig.33
Fig.34
Filling gear oil
Operation_Pic_number:1
● Remove dipstick (A) and pour oil through the
filler hole.
10.2 Checking the transmission
oil level
● Tractor must be on level ground.
● Twist the dipstick and pull out.
● Wipe the dipstick using a clean, fibre-free rag.
● Reinsert dipstick fully and twist into place.
● Twist the dipstick and remove again.
The oil level must reach the upper notch on the
dipstick.
Difference in oil volume between min. and max.
marks on dipstick is approx. 3 litres.
Fig.35