Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
148
CARE AND MAINTENANCE
8. Brake and clutch sy-
stem
Reservoir in the steering column
Operation_Pic_number:1
● Fill up the reservoir (arrowed) to 'MAX' using
only hydraulic oil Pentosin CHF 11S.
DANGER:
The brake system should be
checked thoroughly at regular
intervals.
Brake system adjustment and repair
operations should be performed by
specialised workshops or
authorised brake services!
If there is continuous loss of
hydraulic oil from the brake and
clutch system, contact the Service
Workshop.
Fig.27
Oil level switch
Operation_Pic_number:1
Function check:
● Unscrew and remove the cover.
● Bring float (arrowed) to lowest position.
● Turn ignition key to position 'I'.
Operation_Pic_number:1
The 'brake fluid level' symbol must appear on the
multiple display, with intermittent audible signal
and warning lamp flashing.
NOTE:
The clutch and brake system is maintenance-
free!
Fig.28
Fig.29