Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
142
CARE AND MAINTENANCE
4. Fuel system
4.1 Replacing the fuel filter
Replacement and maintenance as indicated in
the maintenance schedule, or sooner if engine
performance begins to fall.
Fuel filter
Operation_Pic_number:1
● Turn off the engine.
● Unscrew the filter cartridge (A).
● Collect any escaping fuel.
● Clean away any dirt from the sealing surface
of the filter support.
● Lightly oil the oil seals or spray with diesel.
● Tighten the filter cartridge by hand until the
seal is in contact.
● Tighten the housing cover by another half
turn (to 25 Nm).
● Start engine. Check for leaks.
NOTE:
Used fuel filters should be treated as special
waste.
DANGER:
Never allow naked flames when
working on the fuel system.
Do not smoke.
Fig.8
Fuel filter - manual displacement
pump
Operation_Pic_number:1
● Turn off the engine.
● Unscrew the housing cover.
● Collect any escaping fuel.
● Clean away any dirt from the sealing surface
of the filter support.
● Change the filter element.
● Lightly oil the oil seal or spray with diesel.
● Tighten the housing cover.
● Start engine.
● Check for leaks.
Fig.9