Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
141
CARE AND MAINTENANCE
3.3 Filling with engine oil
Operation_Pic_number:1
● Fill with the required engine oil through filler
neck (A). Ensure cleanliness!
Fig.5
3.4 Checking engine oil level
Operation_Pic_number:1
● Tractor must be on level ground.
● Start the engine and allow the engine on idle
till the warning indication on the multiple dis-
play goes out.
● Check the oil drain plug and filter for leaks.
● Turn off the engine.
● After about 5 minutes, take out the dipstick
(B).
Operation_Pic_number:1
● Wipe dipstick with a clean and lint-free rag.
● Reinsert fully and turn.
● Remove dipstick again.
● Top up if necessary, do not fill above MAX
mark.
Oil level must remain between the MIN and MAX
marks on the dipstick. Do not fill over the MAX
mark.
Text-module
Difference in engine oil quantities
The difference between MIN and MAX marks on
the dipstick represents approx. 5.0 litres.
Fig.6
Fig.7