Operating Manual
Table Of Contents
- OPERATING MANUAL
- NUMERICAL INDEX
- SAFETY INSTRUCTIONS
- OPERATION
- 1. Driver seat
- 2. Display instruments and operating controls
- 3. Heating and ventilation
- 4. Rearwiew mirror
- 5. Start-up
- 6. Starting and stopping the engine
- 7. Vario transmission
- 8. Fuel consumption measurement
- 9. Tractor Management System (TMS)
- 10. PTO
- 11. Four wheel drive (4-WD)
- 12. Differential lock
- 13. Front axle suspension
- 14. Power lift and PTO automatic mode
- 15. Brakes
- 16. Steering
- 17. Hydraulics
- 18. Electronic lifting gear control, rear
- 19. Three-point link
- 20. Front power lift
- 21. Trailing devices
- 22. Compressed air system
- 23. Additional ballasting
- 24. Track adjustment
- 25. Twin tyres
- 26. On-board computer
- 27. Computer
- 28. Storing the settings
- 29. Implement control
- 30. Variotronic Ti
- CARE AND MAINTENANCE
- 1. General
- 2. Opening the bonnet
- 3. Engine oil change
- 4. Fuel system
- 5. Dry air .lter
- 6. Cooling system
- 7. V belt
- 8. Brake and clutch system
- 9. Front PTO
- 10. Transmission and axle drives
- 11. Four-wheel drive axle
- 12. Power lift
- 13. Hydraulic system
- 14. Steering
- 15. Front wheels
- 16. Heating and ventilation
- 17. Air conditioning
- 18. Windshield washer system
- 19. Cleaning the tractor
- 20. Electrical and electronic systems
- 21. Fuses
- 22. Wiring diagrams
- IMPLEMENTS
- FAULTS AND REMEDIAL ACTIONS
- TECHNICAL DATA
- ALPHABETICAL INDEX
- Important information on service and maintenance
115
OPERATION
27.3 Setting measurement and
counting direction
Operation_Pic_number:1
Text-module
● Press key (F1). The following submenu appe-
ars.
Operation_Pic_number:1
Text-module
Press key (F1), select between:
Real speed
(Radar sensor).
Theoretical speed (the
measurement result is distorted if
there is wheel slip).
Press key (F2), select between:
Measurement only available with
forward travel
(Standard setting).
Measurement only when travelling
in reverse.
Measurement only in forward travel
(in reverse, the calculation is
subtracted).
Fig.274
Fig.275
Text-module
NOTE:
Press ESC to return to previous menu level.
27.4 Manually triggered measu-
ring and counting
Operation_Pic_number:1
Text-module
● Press key (F2 or F3 or F4 or F5) (location
1 - 4). The following submenu appears.
Operation_Pic_number:1
Measurement only in reverse (in
forward travel, the calculation is
subtracted).
Measurement in forward and
reverse.
Set trailed implement width with
rotary control (P1).
Fig.276
Fig.277