User Manual

FENDT 400 Vario COM III, FENDT 700 Vario COM III, FENDT 800 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault code table COM III
Service Training
400 .. 1001- 724 .. 1001- 731 .. 1001- 401 .. 1001- 725 .. 1001- 402 .. 1001- 726 .. 1001- 403 .. 1001- 727 .. 1001- 404 .. 1001- 729 .. 1001-
0000 B T000434
Version 1
20/09/2007
37
Crop_this_page
9.1.B0 B040 - Sensor, front power lift posi-
tion
Not calibrated No position control
available
FRONT POWER LIFT
Calibration code "9002"
9.1.B1 B040 - Sensor, front power lift posi-
tion
Signal fault No position control
available
Wiring diagram
Sheet 27
FRONT POWER LIFT
8.5 V supply fault A013 fuse 11
9.1.B2 A004 - ECU, control panel
Depth control specified value poten-
tiometer
Not calibrated Specified value can-
not be set
FRONT POWER LIFT
Calibration code "9001"
9.1.B3 A004 - ECU, control panel
Depth control specified value poten-
tiometer
Signal fault, Specified value can-
not be set
FRONT POWER LIFT
9.1.C0 A004 - ECU, control panel
Control panel
Not available or bus not con-
nected
9.1.C1 A004 - ECU, control panel
Automatic system (switching from
control panel/joystick)
Faulty button FRONT POWER LIFT
9.1.C2 A004 - ECU, control panel
Valve locking
Faulty button FRONT POWER LIFT
9.1.C3 A004 - ECU, control panel
Floating position
Faulty button FRONT POWER LIFT
9.1.C4 A004 - ECU, control panel
"Raise" quick lift switch
Faulty button FRONT POWER LIFT
9.1.C5 A004 - ECU, control panel
"Lower" quick lift switch
Faulty button FRONT POWER LIFT
9.1.C6
9.1.C7
9.1.C8
9.1.C9
9.1.CA
A004 - ECU, control panel CAN bus faulty Unspecified malfunc-
tions
Fault
code
DIN brief description Cause Consequences Reference FENDIAS / Note