User Manual

FENDT 400 Vario COM III, FENDT 700 Vario COM III, FENDT 800 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault code table COM III
400 .. 1001- 724 .. 1001- 731 .. 1001- 401 .. 1001- 725 .. 1001- 402 .. 1001- 726 .. 1001- 403 .. 1001- 727 .. 1001- 404 .. 1001- 729 .. 1001-
0000 B T000434
Version 1
20/09/2007
26
Crop_this_page
5.1.65 A004 - ECU, control panel
"Suspension OFF/Lock" button
Fault in signal from button to
A004
Suspension not oper-
ational. Further travel
without suspension
possible
ENHANCED CONTROL
SUSPENSION
5.1.6E B003 - Sensor, front axle suspen-
sion position
Incorrect calibration Suspension not oper-
ational
ENHANCED CONTROL
SUSPENSION
Calibration code "7666"
5.1.8D A002 - ECU, enhanced control Checksum error old config.
data
Limited enhanced
control operation
EOL programming
5.1.8F A002 - ECU, enhanced control Checksum error old auto sys-
tem sequence data
Limited enhanced
control operation
EOL programming
5.1.91 A034 - Driving switch, CAN bus Signal fault from "Rear auto-
matic system ON/OFF" button
on joystick
Rear automatic sys-
tem not functioning
JOYSTICK
5.1.93 A034 - Driving switch, CAN bus Signal fault from "Front auto-
matic system ON/OFF" button
on joystick
Front automatic sys-
tem not functioning
JOYSTICK
5.1.95 A034 - Driving switch, CAN bus Signal fault from "Automatic
function STOP" button on joy-
stick
Automatic stop not
functioning
REAR EPC ACTUATION; JOY-
STICK
5.1.98 S025 - Switch, LS pump pressure
monitor
Minimum pressure not
reached
Valves may lock or
flow may be reduced
Wiring diagram
Sheet 26
See also Chapter
9000 Reg. E
Fault code only after min. 1
second > 1000 rpm
5.1.99 S026 - Switch, steering pump flow
controller
Minimum flow not reached Control valve flow au-
tomatically reduced
to 20 l/min.
Wiring diagram
Sheet 26
See also Chapter
9000 Reg. E
Fault code only after min. 1
second > 1000 rpm
Fault
code
DIN brief description Cause Consequences Reference FENDIAS / Note