User Manual

FENDT 400 Vario COM III, FENDT 700 Vario COM III, FENDT 800 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault code table COM III
Service Training
400 .. 1001- 724 .. 1001- 731 .. 1001- 401 .. 1001- 725 .. 1001- 402 .. 1001- 726 .. 1001- 403 .. 1001- 727 .. 1001- 404 .. 1001- 729 .. 1001-
0000 B T000434
Version 1
20/09/2007
21
Crop_this_page
4.1.86 B008 - Sensor, high-pressure 1
B039 - Sensor, high-pressure 2
Plausibility error between
B008 sensor (transmission
drive pressure) and B039 sen-
sor (push detection)
Loss of enhanced
control when driving
("no active hold func-
tion"), TMS switched
off
TRANSMISSION
TEMPOMAT cruise control
4.1.87 S061 - Switch, quick reverse Plausibility error at VR switch,
quick reverse
VR switch inoperable,
quick reverse on
steering wheel ad-
justment lever, S061
switch,
Check quick reverse
Chapter 9000 Reg. E
TRANSMISSION
man. ADJUSTMENT
4.1.88 A034 - Driving switch, CAN bus Plausibility error at the ON/
OFF button of the accelerator
pedal mode
Button not function-
ing
JOYSTICK
CAN - JOYSTICK
4.1.89 B009 - Discharge temperature Plausibility error, transmission
temperature
Sensor or wiring
faulty
TRANSMISSION
TRANSMISSION OIL/FILTER
4.1.94 A034 - Driving switch, CAN bus CAN communication fault be-
tween A002 ECU, enhanced
control and A034 joystick
Driving switch func-
tions limited.
JOYSTICK
CAN - JOYSTICK
4.1.A1 A009 - Actuator unit Turn angle is not reached
within 2 seconds.
Continuation in emer-
gency mode possible
Mechanical check:
check smooth ad-
justment action in
emergency mode.
TRANSMISSION
TRANSMISSION ADJUST-
MENT
4.1.A2 A009 - Actuator unit CAN bus actuation fault Continuation in emer-
gency mode possible
Check CAN bus,
Chapter 9000 Reg. E
TRANSMISSION
TRANSMISSION ADJUST-
MENT
4.1.A3 A009 - Actuator unit Fault or logic error in incre-
mental sensor signal (actual
position signal)
Continuation in emer-
gency mode possible
TRANSMISSION
TRANSMISSION ADJUST-
MENT
4.1.A4 A009 - Actuator unit Fault or logical error in EST
signal.
Continuation in emer-
gency mode possible
TRANSMISSION
TRANSMISSION ADJUST-
MENT
Fault
code
DIN brief description Cause Consequences Reference FENDIAS / Note