User Manual

FENDT 400 Vario COM III, FENDT 700 Vario COM III, FENDT 800 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault code table COM III
400 .. 1001- 724 .. 1001- 731 .. 1001- 401 .. 1001- 725 .. 1001- 402 .. 1001- 726 .. 1001- 403 .. 1001- 727 .. 1001- 404 .. 1001- 729 .. 1001-
0000 B T000434
Version 1
20/09/2007
20
Crop_this_page
4 . 1. 74 S015 - Switch, hand brake
"OPEN/CLOSED" detection
Signal fault TMS is switched off Wiring diagram
Sheet 29
TRANSMISSION
man. ADJUSTMENT
4.1.76 S047 - Switch, engine brake Signal fault TMS is switched off Wiring diagram
Sheet 29
TRANSMISSION
TEMPOMAT cruise control
4.1.77 A034 - Driving switch, CAN bus Acceleration ramp I ... IV
switch faulty
Only acceleration rate
III available
JOYSTICK
CAN - JOYSTICK
4.1.78 S053 - Switch, driver seat Signal from seat switch faulty Selection of direction
of travel is disabled in
accelerator pedal
mode when vehicle is
stationary (the driver
must re-activate the
selection of direction
of travel)
TRANSMISSION
man. ADJUSTMENT
4.1.82 B014 - Sensor, hydrostatic collect-
ing shaft
B015 - Sensor, bevel pinion
B016 - Sensor, travel range detec-
tion
Plausibility error (=speeds do
not match)
Continuation in emer-
gency mode possible
Wiring diagram
Sheet 29
TRANSMISSION
TEMPOMAT cruise control
4.1.83 B014 - Sensor, hydrostatic collect-
ing shaft
B015 - Sensor, bevel pinion
Plausibility error (=speeds do
not match)
Continuation in emer-
gency mode possible
Wiring diagram
Sheet 29
TRANSMISSION
TEMPOMAT cruise control
4.1.84 A034 - Driving switch, CAN bus Plausibility error (F, R, FR,
Tempomat cruise control, de-
fault positions do not match)
Continuation in emer-
gency mode possible
Wiring diagram
Sheet 29
JOYSTICK
CAN - JOYSTICK
4.1.85 B010 - Sensor, engine speed Engine speed sensor does
not report plausible speed
curves. Output speed in-
crease or decrease outside
limits.
Continuation in emer-
gency mode possible
Wiring diagram
Sheet 29
TRANSMISSION
LOAD LIMIT CONTROL
Fault
code
DIN brief description Cause Consequences Reference FENDIAS / Note