User Manual

FENDT 400 Vario COM III, FENDT 700 Vario COM III, FENDT 800 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault code table COM III
400 .. 1001- 724 .. 1001- 731 .. 1001- 401 .. 1001- 725 .. 1001- 402 .. 1001- 726 .. 1001- 403 .. 1001- 727 .. 1001- 404 .. 1001- 729 .. 1001-
0000 B T000434
Version 1
20/09/2007
16
Crop_this_page
4.1.06 B055 - Sensor, foot throttle Signal fault Restricted operation
(no hand throttle, no
memory keys)
Wiring diagram
Sheet 35
TRANSMISSION
LOAD LIMIT CONTROL
Faulty 8.5 V supply A013 fuse 17
4.1.07 B008 - Sensor, high-pressure 1 Signal fault Travel range switch-
ing from 1 to 2 not
possible, TMS
switched off
Wiring diagram
Sheet 29
TRANSMISSION
TURBO CLUTCH
Faulty 8.5 V supply A013 fuse 3
4.1.08 B016 - Sensor, travel range detec-
tion
Signal fault Travel range switch-
ing not possible; cur-
rent travel range is
retained
Wiring diagram
Sheet 29
TRANSMISSION
TRAVEL RANGE
Faulty 8.5 V supply A013 fuse 13
4.1.20 A002 - ECU, enhanced control Accelerator pedal release po-
tentiometer ("slide switch")
not calibrated or EEPROM
checksum error
Driving in accelerator
pedal mode not pos-
sible
JOYSTICK
CAN - JOYSTICK
Calibration code "4010"
4.1.22 A034 - Driving switch, CAN bus Accelerator pedal release po-
tentiometer ("slide switch")
faulty
Throttle pedal mode
inoperable
JOYSTICK
CAN - JOYSTICK
4.1.23 A034 - Driving switch, CAN bus Signal fault
("Tempomat cruise control
on")
Continuation in emer-
gency mode possible
Wiring diagram
Sheet 29
TRANSMISSION, CRUISE
CONTROL
4.1.25 A034 - Driving switch, CAN bus Signal fault
("Quick reverse")
Continuation in emer-
gency mode possible
Wiring diagram
Sheet 29
TRANSMISSION
man. ADJUSTMENT
4.1.26 A034 - Driving switch, CAN bus Driving switch signal "throttle
pedal mode" faulty
Throttle pedal mode
inoperable
JOYSTICK
CAN - JOYSTICK
Fault
code
DIN brief description Cause Consequences Reference FENDIAS / Note