User Manual

all Vario tractors
Tractor / General system
Vario Tractors - Fault Codes
B
Faults
12/1999
0000 000001
B
f
25/58
Capitel Docu-No.
Index
Date Version
Page
Vario Tractors - Fault Codes
4.1.77 A034 Joystick Switch, acceleration
ramp I ... IV faulty
Only acceleration rate III
available
JOYSTICK, CAN -
JOYSTICK
4.1.78 S053 Seat switch Signal fault from seat
switch
Selection of direction of
travel is disabled in
accelerator pedal mode
when vehicle is
stationary (the tractor
driver must re-activate
the selection of direction
of travel)
TRANSMISSION manu.
adjustment
4.1.7E B035 Setpoint engine speed
EDC/EMR rotary
position sensor, 'hand
throttle potentiometer'
Signal fault 'EDC control' circuit
diagram
TRANSMISSION,
AUTOMATIC MAXIMUM
OUTPUT CONTROL,
calibration code '4002'
4.1.7F A003,
A034
Memory key MIN/ MAX
setpoint engine speed
EDC/EMR
Signal fault 'EDC control' circuit
diagram
Joystick
4.1.81 B010
B011
Engine speed Hall
sensor 1/2
Plausibility error
(=speeds do not match)
Continuation in
emergency mode
possible
'Transmission control'
circuit diagram
TRANSMISSION,
CRUISE CONTROL
4.1.82 B014
B015
B016
Drive collector shaft rpm
Hall sensor / driving
mode detection bevel
pinion sensor
Plausibility error
(=speeds do not match)
Continuation in
emergency mode
possible
'Transmission control'
circuit diagram
possible fault;
Potentiometer range
change B016,
Hydrostat.- bevel pinion
sensor
4.1.83 B014
B015
Accumulator shaft/bevel
pinion speed Hall sensor
Plausibility error
(=speeds do not match)
Continuation in
emergency mode
possible
'Transmission control'
circuit diagram
possible fault;
Potentiometer range
change B016,
Hydrostat.- bevel pinion
sensor
4.1.84 A003
or
A034
Joystick switch (V, R,
VR, cruise control,
default position)
Plausibility error
(=signals do not match
logically)
Continuation in
emergency mode
possible
'Transmission control'
circuit diagram
TRANSMISSION manu.
adjustment; joystick
Fault
code
Id code Brief description Description Consequences Link FENDIAS / Note