User Manual

FENDT 900 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault Code Table FENDT 900 Vario – COM III
919 .. 1001- 934 .. 1001- 922 .. 1001- 925 .. 1001- 928 .. 1001- 931 .. 1001-
0000 B T000002
Version 3
21/09/2007
54
Crop_this_page
18.1.4C A050 - ECU, basic control unit Invalid settings (BSAC) for
controller in EEPROM
18.1.5C A050 - ECU, basic control unit Invalid parameters for control-
ler in EEPROM
18.1.66 Y087 - Steering valve block, Autogu-
ide
Wire for flow measurement
broken or short circuited
18.1.69 Y087 - Steering valve block, Autogu-
ide
Supply voltage over 32 V
18.1.6A Y087 - Steering valve block, Autogu-
ide
Supply voltage below 10 V
18.1.6B Y087 - Steering valve block, Autogu-
ide
Actuator cannot reach neutral
18.1.6C Y087 - Steering valve block, Autogu-
ide
Actuator not in neutral during
"RUNUP"
18.1.6D Y087 - Steering valve block, Autogu-
ide
Actuator position greater than
reference position
18.1.7F Y087 - Steering valve block, Autogu-
ide
EHL system error
18.2.05 S053 - Switch, driver seat Seat not "loaded" when steer-
ing is activated
18.2.40 A050 - ECU, basic control unit Warning message when at-
tempting to fully activate —
no BSAC connection
18.2.70 Y087 - Steering valve block, Autogu-
ide
Warning message when ISO
is inactive
If the following errors occur (1E.1…) they must be deleted in the engine control unit following error correction with SERDIA!
1E.1.00 A051 - ECU, engine control unit
(EDC 7).
Original error, Deutz SERDIA (delete error)
Fault
code
DIN brief description Cause Consequences Reference FENDIAS/Note