User Manual

FENDT 900 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault Code Table FENDT 900 Vario – COM III
Service Training
919 .. 1001- 934 .. 1001- 922 .. 1001- 925 .. 1001- 928 .. 1001- 931 .. 1001-
0000 B T000002
Version 3
21/09/2007
53
Crop_this_page
18.1.2C B081 - Steering wheel sensor (360°) Invalid calibration values for
steering wheel sensor in EEP-
ROM
18.1.30 Y087 - Steering valve block, Autogu-
ide
Unknown error from steering
valve
18.1.31 Y087 - Steering valve block, Autogu-
ide
Error with supply voltage from
steering valve
18.1.32 Y087 - Steering valve block, Autogu-
ide
Warning for steering valve ac-
tuator position
18.1.33 Y087 - Steering valve block, Autogu-
ide
Error with steering valve actu-
ator position
18.1.34 Y087 - Steering valve block, Autogu-
ide
Error with steering valve actu-
ation
18.1.35 Y087 - Steering valve block, Autogu-
ide
Error with steering valve hard-
ware
18.1.36 Y087 - Steering valve block, Autogu-
ide
Warning for steering valve
FLASH, E²PROM and soft-
ware
18.1.37 Y087 - Steering valve block, Autogu-
ide
Error with steering valve
FLASH, E²PROM and soft-
ware
18.1.3A Y087 - Steering valve block, Autogu-
ide
No response from valve
18.1.3B Y087 - Steering valve block, Autogu-
ide
Steering valve does not return
to neutral on switch-off
18.1.3C Y087 - Steering valve block, Autogu-
ide
Invalid calibration values for
steering valve in EEPROM
18.1.4A A050 - ECU, basic control unit Communication with TopDock
interrupted
Last steering com-
mand is retained
Fault
code
DIN brief description Cause Consequences Reference FENDIAS/Note