User Manual

FENDT 900 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault Code Table FENDT 900 Vario – COM III
919 .. 1001- 934 .. 1001- 922 .. 1001- 925 .. 1001- 928 .. 1001- 931 .. 1001-
0000 B T000002
Version 3
21/09/2007
46
Crop_this_page
0B.1.B2 A050 - ECU, basic control unit
TEACH-IN
EEPROM checksum error, ini-
tialising sequence data stor-
age
0B.1.B3 A050 - ECU, basic control unit "No memory available for se-
quence data or configuration/
sequence data do not match"
0B.1.B4 A050 - ECU, basic control unit
TEACH-IN
Configuration wizard: error
with writing or reading set-
tings and parameters on trac-
tor start-up/end or formula
management
0F.1.01 E066 - Brake and tail light left Function non-operable Brake light, left
dipped for night driv-
ing
Circuit diagram
Sheet 13/14
0F.1.02 E067 - Brake and tail light right Function non-operable Brake light, right
dipped for night driv-
ing
Circuit diagram
Sheet 13/14
0F.1.03 E055 - Wide vehicle marker lights,
left
Function non-operable Circuit diagram
Sheet 14
0F.1.04 E054 - Wide vehicle marker lights,
right
Function non-operable Circuit diagram
Sheet 14
0F.1.05 E098 - Drive headlight (main beam),
right
E100 - Drive headlight (main beam),
left
Function non-operable Auto switchover to
additional headlight
Circuit diagram
Sheet 13
0F.1.06 E099 - Drive headlight (dipped
beam), right
E101 - Drive headlight (dipped
beam), left
Function non-operable Auto switchover to
additional headlight
Circuit diagram
Sheet 13
0F.1.07 E003 - H4 additional headlight, right
E004 - H4 additional headlight, left
Function non-operable Auto switchover to
front headlight
Circuit diagram
Sheet 13
Fault
code
DIN brief description Cause Consequences Reference FENDIAS/Note