User Manual

FENDT 900 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault Code Table FENDT 900 Vario – COM III
Service Training
919 .. 1001- 934 .. 1001- 922 .. 1001- 925 .. 1001- 928 .. 1001- 931 .. 1001-
0000 B T000002
Version 3
21/09/2007
25
Crop_this_page
06.1.E0 A050 - ECU, basic control unit Checksum error, parameter
current control for speed se-
lector
EOL programming
06.1.E1 A050 - ECU, basic control unit Checksum error, PTO parame-
terisation
Use default values EOL programming
06.1.E2 A050 - ECU, basic control unit Error in checksum PW rise of
rear PTO
Use default values EOL programming
06.1.E3 A050 - ECU, basic control unit Checksum error, for PW of
PTO
Use default values EOL programming
06.1.E4 A050 - ECU, basic control unit Checksum error, over/under
step counter of PTO
Use default values EOL programming
06.1.E5 A050 - ECU, basic control unit Checksum error, speed limit
sensor after rear PTO clutch
Use default values EOL programming
06.1.E6 A050 - ECU, basic control unit Checksum error, pulses per
revolution for shuttle stub
shaft
Use default values EOL programming
06.1.E7 A050 - ECU, basic control unit Checksum error for tempera-
ture limits and switching
times of rear PTO
Use default values EOL programming
06.1.E8 A050 - ECU, basic control unit Checksum error, masks for
showing/hiding diagnostics on
front and rear PTOs
Use default values EOL programming
07.1.01 A039 - MFA, multifunction armrest
Button, front PTO ON/OFF
Signal fault, button/A004 FRONT PTO ENHANCED
CONTROL
Bus fault A004/A002
07.1.04 Y011 - Solenoid valve, front PTO
(clutch)
Actuation fault Circuit diagram
Sheet 11
FRONT PTO ENHANCED
CONTROL
07.1.05 B002 - Sensor, front PTO speed Sensor faulty,
Signal fault
Circuit diagram
Sheet 10
FRONT PTO ENHANCED
CONTROL
Fault
code
DIN brief description Cause Consequences Reference FENDIAS/Note