User Manual

FENDT 900 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault Code Table FENDT 900 Vario – COM III
Service Training
919 .. 1001- 934 .. 1001- 922 .. 1001- 925 .. 1001- 928 .. 1001- 931 .. 1001-
0000 B T000002
Version 3
21/09/2007
17
Crop_this_page
04.1.E2 A050 - ECU, basic control unit Pressure regulator control pa-
rameters in tractive power
control not plausible (B008/
B039) or read incorrectly.
EOL
programming
04.1.E3 A050 - ECU, basic control unit Checksum error, parameter
for throttle pedal mode
Emergency mode
TMS is switched off
EOL
programming
04.1.E4 A050 - ECU, basic control unit Checksum error, electronic
cardan brake parameters
EOL
programming
04.1.E5 A050 - ECU, basic control unit Checksum error, range con-
trol, faulty speed limiting valve
etc.
Range control not
possible
EOL
programming
04.1.E6 A050 - ECU, basic control unit Incorrect checksum, load limit
control parameters
Emergency mode,
transmission
EOL
programming
04.1.E7 A050 - ECU, basic control unit Incorrect checksum, joystick
parameters
Possible to drive with
default values
EOL
programming
04.1.E9 A050 - ECU, basic control unit Incorrect parameters, range
control addresses 950-994
EOL
programming
04.1.EA A050 - ECU, basic control unit Error in checksum parameter
for transmission teeth
number
Continuation in emer-
gency mode possible
EOL
programming
04.1.EB B016 - Sensor, travel range detection Checksum error or
no range control calibration
04.1.EC B055 - Sensor, foot throttle No calibration or
drifted, changed values
Continuation in emer-
gency mode possible
TRANSMISSION, LOAD
LIMIT CONTROL, calibra-
tion code "4005"
04.1.ED B017 - Sensor, clutch pedal No calibration or
drifted, changed values
Continuation in emer-
gency mode possible
TRANSMISSION, TRAVEL
RANGE, calibration code
"4001"
Fault
code
DIN brief description Cause Consequences Reference FENDIAS/Note