User Manual

FENDT 900 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault Code Table FENDT 900 Vario – COM III
Service Training
919 .. 1001- 934 .. 1001- 922 .. 1001- 925 .. 1001- 928 .. 1001- 931 .. 1001-
0000 B T000002
Version 3
21/09/2007
9
Crop_this_page
02.1.EE A050 - ECU, basic control unit Error message from LBS job
controller
02.1.EF A050 - ECU, basic control unit Internal tractor GD error mes-
sage
03.1.01 A039 - MFA, multifunction armrest Faulty hardware (e.g. RAM
without flash)
Function non-opera-
ble
EOL
programming
03.1.02 A039 - MFA, multifunction armrest Incorrect checksum for the
first 128 bytes in the EEPROM
Function non-opera-
ble
EOL
programming
03.1.03 A039 - MFA, multifunction armrest Software error Function non-opera-
ble
EOL
programming
03.1.08 A039 - MFA, multifunction armrest Invalid parameters for flashing
in EEPROM
EOL
programming
03.1.09 A039 - MFA, multifunction armrest Invalid parameters for bright-
ness setting in the EEPROM
EOL
programming
03.1.18 A039 - MFA, multifunction armrest Invalid parameters for acceler-
ation rate
Uses predefined val-
ues
EOL
programming
03.1.20 A039 - MFA, multifunction armrest Invalid parameter for cross-
gate lever
Uses predefined val-
ues
EOL
programming
03.1.30 A039 - MFA, multifunction armrest Invalid parameters for linear
module (valve rockers)
Uses predefined val-
ues
EOL
programming
03.1.40 A039 - MFA, multifunction armrest Invalid parameters for hand
throttle and throttle pedal
speed range
Uses predefined val-
ues
EOL
programming
03.1.50 A039 - MFA, multifunction armrest Invalid parameters for FRONT
power lift module
Uses predefined val-
ues
EOL
programming
03.1.60 A039 - MFA, multifunction armrest Invalid parameters for REAR
power lift module
Uses predefined val-
ues
EOL
programming
Fault
code
DIN brief description Cause Consequences Reference FENDIAS/Note