User Manual

Fendt 300 Vario
Tractor / General system
Vario Tractors - Fault Codes
B
Faults
12.06.2006
0000 000022
B
b
16/21
Capitel Docu-No.Index
Date Version
Page
Vario Tractors - Fault Codes
1E.1.06
B085,
B088
Camshaft speed sensor,
crankshaft speed sensor
Camshaft speed signal,
shaft faulty or signal
missing; crankshaft
speed signal faulty or
missing;
camshaft/crankshaft
speed signals out of
phase
Irregular running Circuit diagram 'Deutz
engine control'
SERDIA (clear fault)
FC:004B, 004C, 004D,
004E, 004F, 0050
1E.1.07
B091 Water separator sensor Fuel filter sensor/water
separator, cable break or
short circuit, water level
higher than target range
Drain water from fuel filter Circuit diagram 'Deutz
engine control'
SERDIA (clear fault)
FC:0057, 0059
1E.1.08
B087 Fuel low pressure sensor Cable break or short
circuit. Fuel low pressure
below target range
Check fuel system, may
be air in system or filter
clogged
Circuit diagram 'Deutz
engine control'
SERDIA (clear fault)
FC:005A, 005B, 005E
1E.1.0A
B035 Hand throttle sensor Cable break or short
circuit. Signal from hand
throttle implausible
Circuit diagram'EDC
control'
SERDIA (clear fault)
FC:008A
1E.1.0E
B090,
B093
Sensor, engine oil
pressure
Cable break or short
circuit. Oil pressure
outside target range
Circuit diagram 'Deutz
engine control'
SERDIA (clear fault)
FC:00C4, 00C5, 00C6,
00C7
1E.1.12
S002 Ignition switch Pin 50, engine start
switch hangs
Circuit diagram'EDC
control'
SERDIA (clear fault)
FC:00E3, 00E4
1E.1.13
A051 ECU, engine control unit
(EDC7)
Driving speed above
target range, signal faulty
Circuit diagram'EDC
control'
SERDIA (clear fault)
FC:00E8
1E.1.14
B055 Foot throttle sensor Cable break or short
circuit. Signal not
plausible with signal from
foot throttle sensor
Speed is maintained, can
be taken over with hand
throttle by briefly
increasing speed
Circuit diagram'EDC
control'
SERDIA (clear fault)
FC:000C, 000E, 000F
1E.1.21
K063 Heater relay Cable break or short
circuit
Preheating system does
not function
Circuit diagram 'Deutz
engine control'
SERDIA (clear fault)
FC:0011
1E.1.22
K063 Heater relay Cable break or incorrectly
connected
Preheating system does
not function
Circuit diagram 'Deutz
engine control'
SERDIA (clear fault)
FC:0013, 0014
1E.1.23
S047 Engine brake Cable break or short
circuit
Circuit diagram'EDC
control'
SERDIA (clear fault)
FC:0034
Fault
code
Id code Brief description Description Consequences Link FENDIAS / Note