User Manual

Fendt 300 Vario
Tractor / General system
Vario Tractors - Fault Codes
B
Faults
12.06.2006
0000 000022
B
b
10/21
Capitel Docu-No.Index
Date Version
Page
Vario Tractors - Fault Codes
05.1.61
B003 Suspension position
sensor
Signal fault No further functions
available, suspension
remains in last position.
Continuation without
suspension possible
'Suspension' circuit
diagram
ENHANCED CONTROL
SUSPENSION
8.5 V supply fault A013 fuse 5
05.1.62
Y014 'Raise' suspension
solenoid valve
12V control fault No further functions
available, suspension
remains in last position.
Continuation without
suspension possible
'Suspension' circuit
diagram
ENHANCED CONTROL
SUSPENSION
05.1.63
Y013 'Lower' suspension
solenoid valve
12V control fault No further functions
available, suspension
remains in last position.
Continuation without
suspension possible
'Suspension' circuit
diagram
ENHANCED CONTROL
SUSPENSION
05.1.64
A036 'Suspension ON' key Signal from key is faulty Suspension not
operational. Continuation
without suspension
possible
ENHANCED CONTROL
SUSPENSION
05.1.66
Y012 Valve, charge suspension Actuation fault Suspension moves to
'Lock' status.
05.1.6E
B003 Suspension position
sensor
Incorrect calibration Suspension not
operational
ENHANCED CONTROL
SUSPENSION calibration
code '7666'
05.1.9D
A051,
B091
Sensor, water separator Water in fuel Drain water from tank Circuit diagram 'Deutz
engine control'
05.1.B0
A002 ECU, enhanced control CAN-bus communication
restricted
EOL programming
05.1.FF
A002 ECU, enhanced control Internal fault (RAM /
EEPROM)
EOL programming
06.1.01
A036 Rear PTO ON / OFF key
in cab
Key signal fault PTO disengages 'PTO's' circuit diagram REAR PTO ENHANCED
CONTROL
Fault
code
Id code Brief description Description Consequences Link FENDIAS / Note