User Manual

Fendt 300 Vario
Tractor / General system
Vario Tractors - Fault Codes
B
Faults
12.06.2006
0000 000022
B
b
7/21
Capitel Docu-No.
Index
Date Version
Page
Vario Tractors - Fault Codes
04.1.85
B010 Engine speed
Hall sensor 1
Engine speed sensor
does not supply plausible
speed curves. Output
speed increase or
decrease is outside limits.
Continuation in
emergency mode
possible
'Transmission control'
circuit diagram
TRANSMISSION, LOAD
LIMIT CONTROL
04.1.87
S061 Switch, rapid reverse on
the steering wheel
adjustment
Plausibility error at the F /
R switch, rapid reverse
F / R switch not
functioning, rapid reverse
on the steering wheel
adjustment lever, S061-
switch,
Check rapid reverse
Chapter 9000 Reg. E
TRANSMISSION manual
control
04.1.89
A007,
B009
Switch, oil temperature Plausibility error
transmission temperature
Temperature sensor or
wiring faulty
TRANSMISSION
TRANSMISSION OIL
04.1.8 A
B017,
S074
Sensor, clutch pedal Plausibility error electrical
clutch pedal (TC line does
not open when clutch
pedal is actuated)
'Transmission control'
circuit diagram
TRANSMISSION
TURBOCLUTCH
FUNCTION
04.1.A1
A009 Transmission control unit Turn angle is not reached
within 2 seconds.
Continuation in
emergency mode
possible
Check transmission
control unit Chapter 9000
Reg. E
TRANSMISSION,
TRANSMISSION
CONTROL
04.1.A2
A009,
A002
Transmission control unit CAN-bus actuation fault Continuation in
emergency mode
possible
Chapter 9000 Reg. E -
Testing CAN BUS
TRANSMISSION,
TRANSMISSION
CONTROL
04.1.A3
A009 Transmission control unit Fault or logical error in
incremental sensor signal
(actual position signal)
Continuation in
emergency mode
possible
'Transmission control'
circuit diagram
TRANSMISSION,
TRANSMISSION
CONTROL
04.1.A4
A009 Transmission control unit Fault or logical error in
ECU signal.
Continuation in
emergency mode
possible
'Transmission control'
circuit diagram
TRANSMISSION,
TRANSMISSION
CONTROL
04.1.A5
A009 Transmission control unit Initial reference (=zero
position) could not be
reached during ignition
'ON'
Continuation in
emergency mode
possible
'Transmission control'
circuit diagram
TRANSMISSION,
TRANSMISSION
CONTROL
04.1.A6
A009 Transmission control unit Reference point signal
fault during operation
Continuation in
emergency mode
possible
TRANSMISSION,
TRANSMISSION
CONTROL
Fault
code
Id code Brief description Description Consequences Link FENDIAS / Note