User Manual

FENDT 400 Vario COM III, FENDT 700 Vario COM III, FENDT 800 Vario COM III Faults
B
OVERALL SYSTEM/TRACTOR
Fault code table COM III
400 .. 1001- 724 .. 1001- 731 .. 1001- 401 .. 1001- 725 .. 1001- 402 .. 1001- 726 .. 1001- 403 .. 1001- 727 .. 1001- 404 .. 1001- 729 .. 1001-
0000 B T000434
Version 1
20/09/2007
44
Crop_this_page
A.1.50 S053 - Switch, driver seat Seat not "loaded" when steer-
ing is activated
A.1.51 B094 - Sensor, steering angle (4WD
differential lock)
Despite the steering valve be-
ing open, the steering angle
sensor produces no fresh val-
ues within 1 second
Steering angle sen-
sor mechanical fault,
no hydraulic oil in the
steering valve
A.1.52 B094 - Sensor, steering angle (4WD
differential lock)
Invalid calibration values for
steering angle sensor in EEP-
ROM
A.1.53 A058 - Top Dock (Autoguide) Top Dock bus fault No signal from Top
Dock to transmission
bus
Top Dock voltage
supply
A.1.55 A057 - ECU, steering controller (Au-
toguide)
An EEPROM description fault
has occurred
EOL programming
If there is no remedy, replace
box
A.1.56 A057 - ECU, steering controller (Au-
toguide)
An EEPROM reading fault has
occurred
EOL programming
If there is no remedy, replace
box
A.1.57 A057 - ECU, steering controller (Au-
toguide)
The EEPROM contains invalid
data
EOL programming
A.1.5A A057 - ECU, steering controller (Au-
toguide)
Invalid EEPROM parameters
for the steering control regula-
tor
Invalid data set EOL programming
A.1.5B A057 - ECU, steering controller (Au-
toguide)
Invalid EEPROM parameters
for the steering control regula-
tor
Invalid data set EOL programming
A.1.5C A057 - ECU, steering controller (Au-
toguide)
Invalid EEPROM parameters
for the steering control regula-
tor
Invalid data set EOL programming
Fault
code
DIN brief description Cause Consequences Reference FENDIAS / Note