Reference and Owner’s Manual for the SFX Keyboard 200 P/N 053448 REV C
A Message from the Chairman Since 1946, Fender realized the importance of your amplifier. You see, your amplifier is more than just a combination of dials, wires and speakers. It is a finely tuned musical instrument. And like any fine musical instrument, it should be treated with special care and attention to detail. At Fender, we know what building guitar amplifiers is all about.
YOUR SFX KEYBOARD 200 AMPLIFIER Congratulations on your purchase of a Fender SFX Keyboard 200 Amplifier. Your new Fender amp is designed by the same Tone-Team that has created many other classic Fender amps: like the ToneMaster®, Princeton® Chorus and the versatile Hot Rod Series. Built with care and special attention to detail, your SFX Keyboard 200 offers much more than meets the eye.
SFX KEYBOARD 200 FRONT CONTROL PANEL A. INPUTS - Plug your keyboard in here; these are line level input jacks. If sending a mono signal from your keyboard, plug your cord into the left or L/M input. J. MID - Adjusts the amount of increase or decrease in the middle frequency range of the SFX Keyboard 200’s Stereo Channel 2. B. VOLUME - Adjusts the loudness of the SFX Keyboard 200’s Stereo Channel 1 inputs. K.
X. SFX - Adjusts the amount of Stereo Field eXpansion effect produced by your SFX Keyboard 200 amplifier. Rotating the knob clockwise increases the SFX spatial effect. Likewise, rotating the knob counterclockwise allows the SFX Keyboard 200 to be used as a traditional amp. P. VOLUME - Adjusts the loudness of the SFX Keyboard 200’s mono channel. Q. LOW - Adjusts the amount of increase or decrease in the low frequency range of the SFX Keyboard 200’s mono channel. Y.
SFX KEYBOARD 200 REAR PANEL A. POWER SWITCH - Turns the AC power ON and OFF. When the switch is in the OFF position, the amplifier is completely shut down. B. LINE CORD - This amplifier is equipped with a grounding type supply cord to reduce the possibility of shock hazard. Be sure to connect it to a grounded AC receptacle. The line cord should be connected to a suitable power source in accordance with voltage and frequency as shown in the input power rating on the rear panel. DO NOT ALTER THE AC PLUG. C.
TROUBLESHOOTING CONNECTIONS If the SFX Keyboard 200 is set up but does not function, check the following items: • • • • • • • • • • The SFX Keyboard 200 has a variety of connectors on its input / output panels. Below is a chart listing the various types and their pin outs.
SFX KEYBOARD 200 SPECIFICATIONS TYPE: PR 372 PART NUMBER: 22-8503 22-8533 22-8543 22-8563 22-8573 (120V) (240V) Aust (230V) UK (230V) Eur (100V) POWER REQUIREMENTS: 100V 120V 230V 240V 50/60 Hz 450W 60 Hz, 450W 50 Hz, 450W 50 Hz, 450W POWER AMPLIFIER SECTION POWER OUTPUT: SENSITIVITY : PREAMP SECTION INPUT IMPEDANCE: SENSITIVITY FOR FULL POWER : TONE CONTROLS: AC, AC, AC, AC, 80W R.M.S. per channel, (160W R.M.S. Total) into 8Ω @ <0.18% T.H.D., both channels driven 0.965V (both channels) 18.
