User Manual

fender.com

disply freq

channl

loc set loc off

loc on

Passport Executive

Telecommunications Licensing

• The Transmitter channel must match the receiver

channel displayed on the Passport base unit . To

change the Transmitter channel, first use the

buttons to select a channel, then press the SET button

to confirm your selection.

• You can lock the Transmitter buttons if desired. After

selecting the Display Option (above), use the

buttons to select either "LOCK ON" or "LOCK OFF,"

then press the SET button to confirm your selection.

To unlock, press the SET button and select "LOCK

OFF."

• The Transmitter can display either the transmitting

channel or frequency. To change the display, press the

SET button once. Next use the

buttons to select

either "CHANNEL" or "FREQUENCY," then press the SET

button to confirm your selection.

Channel Selection

Display Options

Button Lock

Wireless Transmitter

DISPLAY—Displays the transmitting channel (or frequency)

and battery strength.

GAIN—Set at the factory for optimal use. Decrease GAIN

only if the Passport Executive sounds distorted even at low

volume settings. Increase GAIN only if the Passport Executive

sounds too quiet even at high volume settings.

BATTERIES—Insert two AA batteries as shown.

POWER—Wireless Transmitter ON-OFF switch.

INPUT JACK—Plug the Headset in here.

SET—Press to activate menus and confirm selections.

UP / DOWN—Press to change channels (frequencies) and

make menu selections.

Headset Microphone

HEADSET—Plug into the Wireless Transmitter Input Jack

A statutory license may be required to operate this equipment in certain areas. Consult your national authority for possible require-

ments. Licensing of Fender equipment is the user’s responsibility, and licensability depends on the user’s classi cation, application,

and frequency selected. Fender strongly urges the user to contact the appropriate telecommunications authority for any desired

clari cation.