Product Info

8
RECORDING
Mustang Micro can be used as digital recording software output by using a USB cable to con-
nect the USB-C jack (H) on the bottom of the unit to the USB port on the user’s Mac or PC.
FIRMWARE UPDATE
To perform a Mustang Micro rmware update, follow these three steps:
1. With Mustang Micro o, press and hold the “+” TONE BUTTON (D).
2. With one end of a USB cable connected to a Mac or PC, connect the other end to Mustang
Micro’s USB-C jack.
3. Release the “+” TONE BUTTON.
Successful initiation of rmware update mode is then indicated by a solid white POWER SWITCH LED (G) for 10
seconds; the white LED will then begin ashing to indicate an update in process.
When a rmware update is complete, the POWER SWITCH LED will illuminate solid green for 10 seconds and then
extinguish to indicate a successful update; the LED will illuminate solid red for 10 seconds and then extinguish to
indicate a failed update. Mustang Micro is automatically powered up during the rmware update process; when
an update is completed successfully, Mustang Micro must then be restarted.
FIRMWARE UPDATE
INITIATED (SOLID)
IN PROCESS (FLASHING)
FIRMWARE UPDATE
SUCCESSFUL (SOLID)
FIRMWARE UPDATE
FAILED (SOLID)
FACTORY RESET
A Mustang Micro factory reset can be performed that resets all buttons (AMP, TONE, FX,
FX LEVEL) to their original factory values and clears the Bluetooth paired device list.
Initiate factory reset mode by turning Mustang Micro on while holding the “+” FX BUT-
TON (E) for three seconds.
Do LEDs do anything during factory reset?