User Manual

This device and its antenna(s) must not beco-located with any other transmitters except
in accordance with IC multi-transmitte rproduct procedures.
Refering to the multi-transmitter policy, multiple-transmitter(s) and module(s) can be
operated simultaneously without reassess ment permissive change.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en
association avec une autre antenne ou transmetteur. This module isintended for OEM
integrator.
The OEM integratorisstillresponsible for the IC compliance requirement of the end
product, whichintegratesthis module.

In the usersmanual of the end product, the end user has to beinformed to keep at least
20cm separation with the antenna while this end product is installed and operated. The
end user has to beinformed that the IC radio-frequencyexposure guidelines for an
uncontrol led environment can be satisfied. The end user has to also be informed that
any changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate this equipment. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
The final end product must belabeled in a visible area with the following " Contains TX
IC : 12425A-F23BUUM13W2".
EU Regulatory Conformance
Hereby, we (FN-Link Technology Limited) declared that this device is in compliance with
the essential requirements and other relevant provisions of Directive 1999/5/EC.