Measurement Guide

For tree protection it is important NOT to afﬁx the product directly to the

tree, there must be approximately a quarter to half an inch of room for the

tree to breathe. By fastening the center holes together with a bolt the

necessary length and height can be achieved to reach the desired

diameter. !

For more unique shapes Fence Armor Round is malleable and can be

formed to ﬁt most shapes.

OFF THE BOX INSTRUCTIONS:

Slide Fence Armor over the bottom of your existing post, at the middle of

the centre line of your grass trimmers path. Place a second unit on the

opposite side of the post, over-lapping each unit until slot and side holes

meet. Fasten with 1 ¼ to 1 ½ inch long galvanized nail or outdoor rated

deck screw. If side holes are not accessible, use the front hole to fasten

with the same type of fastener. For best results stain or waterproof

untreated posts before installing Fence Armor. If required, due to ground or

fence level, you may stack Fence Armor to increase desired protection

area.

For more information refer to our detailed installation sheet.