Installation Instructions

ROUTING ROUTING

BOTTOM BRACKET

CABLE GUIDE

BOTTOM BRACKET

CABLE GUIDE

Continue to insert the cable until the end can be seen through the single port found

closest to the drive-side of the frame. Once located, pull the cable up and out while

still leaving some slack for later steps.

Insert cable back into the port while directing it toward the drive-side chain stay of

the bike, as it will exit out of the port found near the rear derailleur. This will create

a loop on the outside of the frame that you want maintain throughout the rest of the

routing process.

Try an keep the loop roughly the same size as shown in the image above.

For now you can tuck the cable out of the way for later steps.

The cable will exit out of the port found near the rear derailleur.