Installation Instructions

ROUTING ROUTING

BOTTOM BRACKET

CABLE GUIDE

BOTTOM BRACKET

CABLE GUIDE

While keeping the cable threaded from the previous step, insert the loose end back

into the port it entered from, and out of the port found directly behind it.

Then thread the cable back through the bottom bracket cable guide from the bottom

up, as shown in the image above.

Now the cable should be going through the bottom bracket guide twice, and through the

frame once as shown above. Once you have the cable properly threaded, spot the front

derailleur cable exit port through the rear bottom bracket port and guide the loose cable

end through the bottom bracket and out towards the where the front derailleur is located

(As shown in the circle above.) Do not pull the slack out of the cable yet.

Now take the loop created in steps 2 through 6, and simply hook it around the

remaining slot in the bottom bracket guide as shown above.

YES