Operation Manual

9
Problem Possible cause Solution
No lights showing on Cutting base or
Scissor Icon
Machine is not switched on
Switch on machine at rear next to plug
inlet and at the mains socket
Cut button does not work when pressed
(No function when pressed)
Machine not plugged in
Move the machine to a cooler and dry
area
SafeCut™ Guard not in place
Ensure that SafeCut™ Guard is
securely in place
SafeCut™ Guard not closed
Ensure that SafeCut™ Guard is
closed
Paper is cut but cutting head still moves
along machine still continues to cut
PowerTrim is set to complete 6 cut cycles as
default.
To stop PowerTrim before 6 cycles have
been completed, just press the “scissor”
touch button again
Can’t replace cutting strips - not enough
room to lift them
SafeCut™ Clamp closed Open SafeCut™ Clamp
Poor cut quality (Cuts are not very sharp –
edge of cut items not straight)
Cutting strips could be worn out
Turn cutting strip over as described
above to use other side, or replace with
spare part CRC 54125
Cutting blades could be worn out
Replace (with spare part CRC 54125) as
described above
LED warning symbols
Scissor icon is flashing in alternate blue
and red
SafeCut™ Clamp is open when cutting is not
yet complete
Close SafeCut™ Clamp
Scissor icon light is red - no illuminated
cutting base
Motor is too hot when doing continue cut Let trimmer cool down
Scissor icon light not on
SafeCut™ Guard is open or Power not
switched on
Make sure power is switched on and
SafeCut™ Guard is closed
TROUBLESHOOTING
PowerTrim_v2.0_All_Langs.indd 9 12/02/2009 13:59:54