User Manual

Receiver
1. Insert the batteries
a. Press the battery cover switch on the bottom of the mouse to open the battery
compartment.
b. Fit in the batteries accordingly to the diagram indicated in the battery cabinet.
c. Close the battery compartments cover properly.
d. The Low Power LED on the wheel bar will blink 3 seconds if the mouse power is on.
Wheel button
Button 5
Button 4
ID reset button
Mouse
Introduction
Congratulations on your purchase of the most innovative wireless optical mouse. With an
incredible sensitivity to surface details and high tracking speed than other mice, the mouse
can track reliably even on tricky polished or wood-grain surfaces. It offers even more
advance that will make you more productive and more comfortable.
A. Hardware Installation
2.4GHz RF (distance 6~8m)
Using state-of-art technology. High tracking speed and sensitivity.
Longer battery life
16 Channels/4096 ID per channels
Auto-Link, Plug and Play! No need to set the channel ID.
Power on/off button
2*AA Alkaline batteries included
800 dpi
Features
+
-
A wrong battery placement
may cause batteries overheat.
2 AA batteries
Battery
compartment
cover
2. Connect the receiver
a. Turn on your PC.
b. Connect the receiver to USB port on PC
PC
USB port
3. Communication : The mouse
The 2.4Ghz RF mouse features a dual-way transmission technology which enables the
mouse and the receiver auto-communication.
A. Auto-link mode
1. Make sure the Power On-Off Switch on the bottom of the mouse is ON.
2. Operate the mouse, and the LED in the receiver will blink fast. Now the mouse and the
receiver is auto-linked successfully.
B. Manual mode
If you find the communication channel does not connect well, you can use following steps
Press ID reset button
Red Led indicator blinks faster
1
2 34
ID links OK!
Power on/off button
Red LED indicator