User manual

‘System-Check’ function

When switched on, the machine performs a

‘System-Check’ function. The control panel

illuminates LED neons in sequence to check their

operation.

‘Heat-Shield’ function

The document clamp operates as a ‘Heat Shield’ to

prevent operators from accidentally touching the

heating plate.

‘Auto-Off’ function

If the machine is not active for 30 minutes, the

‘Auto-Off’ function will place the machine into

standby mode. The ’Power-On’ LED will flash

red and green. To operate the machine, press the

‘Power-On’ button.

• Always put the document into the appropriate sized

binding cover.

• For better results, consider including blank sheets

to fill the thermal cover to capacity.

• Always test bind with a similar size and thickness of

thermal covers before final process.

• Helios has an angled heater mechanism to ensure

correct document alignment with the document

support during the binding process.

• For best results, use Fellowes® brand supplies.

• Thermal binding covers work best with thin and

uncoated types of paper. Care should be taken

with thick and coated papers to ensure satisfactory

results.

• If the sheets have not been glued completely to the

cover, the document can be re-processed to improve

the result.

• Ensure the sheets are well aligned and touching

the glued spine of the thermal cover. This can be

achieved by tapping collated document in the cover

onto a flat surface. This can be done before and

after the binding process.

A On/off switch (rear side) I Lid lock (2)

B Power On button & LED J Binding channel

C Binding thickness guide K Document support

D Timer selection (increase) L Illuminated user interface

E Timer selection (decrease) M Cooling vents

F Select / OK button N Document clamp (binding)

G Thickness setting / timer selection O Cooling rack

H Lid

BINDING MACHINE CONTROLS

FEATURES & TIPS