Operation Manual

3
MACHINE-SPECIFIC SAFETY WARNINGS
- Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord. Cutting accessory
contacting a “live” wire may make exposed metal parts of
the power tool “live” and could give the operator an electric
shock.
- Keep hands away from the sawing range.
Do not reach under the workpiece. Contact with the saw
blade can lead to injuries.
- Apply the machine to the workpiece only when switched on.
Otherwise there is danger of kickback when the cutting tool
jams in the workpiece.
- Pay attention that the base plate 8 rests securely
on the material while sawing. A
jammed saw blade can break or lead to kickback.
- When the cut is completed, switch off the machine and
then pull the saw blade out of the cut only after it has come
to a standstill. In this manner you can avoid kickback and can
place down the machine securely.
 -Useonlysharp,awlesssawblades.Bentorunsharp
saw blades can break or cause kickback.
- Do not brake the saw blade to a stop by applying side
pressure after switching off. The saw blade can be damaged,
break or cause kickback.
- Use suitable detectors to determine if utility lines are
hidden in the work area or call the local utility company for
assistance.Contact with electriclines canlead to reand
electric shock. Damaging a gas line can lead to explosion.
Penetrating a water line causes property damage or may
cause an electric shock.
- Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than by
hand.
 -Keepyourworkplace clean.Blendsofmaterials are
particularly dangerous. Dust from light alloys can burn or
explode.
- Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam and lead
to loss of control over the power tool.
- Never use the machine with a damaged cable. Do not
touch the damaged cable and pull the mains plug when the
cable is damaged while working. Damaged cables increase
the risk of an electric shock.