FeiYu Tech FeiYu X4 QuadCopter Frame Instruction Manual Please read the manual carefully before using FeiYu X4 Guilin Feiyu Electronic Technology Co., Ltd 4th Floor,Yu Tai Jie Science&technology Building, Information Industry Park, ChaoYang Road ,Qi Xing District , Guilin 541004, China. http://www.feiyudz.cn Email: service@feiyu-tech.
GuiLin FeiYu Electronic Technology Co., Ltd Features 1. Dimensions copter 450mm 705mm Diameter Top Diameter 2. Empty Frame Weight: 580g (receiver and battery not included) 3. Payload Capability: 700g ( battery, receiver, and camera included) 4. Maximum Gross Take-Off Weight: 1380g. DO NOT OVERLOAD ON FeiYu X4 WHICH CAN LEAD TO DANGER. 5. Airborne period: >10mins (with 3S 2200mAh battery) 6. Cell Chemistry: 3S 1500mAh ~ 5000mAh Lithium Polymer, and instant discharge capacity >15C.
GuiLin FeiYu Electronic Technology Co., Ltd Install Tools needed to build the X4: Soldering Iron Rosen Core Solder Allen Wrench (provided) Step 1:Frame Arm Assembly prop eller Note: There are three LED on the side of arm,The LED should on out side. Brushless motro M3*5mm Scoket Screw M3×30mm Pillar Right Arm FrameM3×5mm Arm Assembly Scoket Screw Left Arm soldering point soldering point Leg Unpack the Frames, separate them as to color of l.e.d.’s i.e. Blue, Red, Green.
GuiLin FeiYu Electronic Technology Co., Ltd Go through the same procedure for the remaining three frames. Inspect the assemblies to be sure that all the motors and the landing gears are seated properly. When assembled properly, the Feiyu Tech Logo’s will be facing upright and the Welding points will all be lined up. Step 2:Building the Fuselage and attaching and Welding the Frames to the Fuselage. Unpack the three Frame assemblies.
GuiLin FeiYu Electronic Technology Co., Ltd Fuselage with Electronic components Cross any two wire , change Motor rotation welding Magic cable tie through square groove ESC M3×25mm Pillar Step 3: Welding (soldering) the frames to the bottom fuse plate with the electronics. To accomplish this you will need a small soldering iron aprox. 35w. Plug in the soldering iron and while it is coming to temperature, gather your Rosen Core solder and safety glasses. With the soldering iron at temp.
GuiLin FeiYu Electronic Technology Co., Ltd The Magic cable tie use for fixed battery. The frame Power detection support 3S (11.1V )battery. Connect a 3S Lipo Balance plug to the plug on the bottom of the Fuselage. Power detection: Fuselage Led flash. Status LED on Slow flash Medium flash Fast flash battery >11.5V 11.1V~11.5V 10.8V~11.1V <10.8V Enough power Voltage reduction Need landing Landing immediately note Step 4: Installing the ESC’s and the Battery connector.
GuiLin FeiYu Electronic Technology Co., Ltd Propeller installation Front 1 4 2 3 Pay attention to the installation of the propeller direction. QuadCopter Layout: 1 = ESC 1 CCW 2 = ESC 2 CW 3 = ESC 3 CCW 4 = ESC 4 CW cw = clock wise ccw = counter clockwise ——END—— Note: We reserve the right to change this manual at any time! And the newest edition will be shown on our website www.feiyudz.cn. GuiLin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn Page 6 E-mail: service@feiyu-tech.
