Owner's manual

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [e-mail]
Page 37
110.283 in the longitude edit box,25.277 in the latitude edit box, click on ‖ OK ‖ button, it
will mark the landing starting point at the target coordinates on the map, show as the
following interface.
(Landing ending point please refer to the operation of the setting for landing starting
point.)
14.5 RC Switch (SW2) Setting
Sw2, the three position switch which control navigation working modes can
configurate via the GCS software.‖Menu‖——―Autopilot setting‖——―RC Setting‖ click on
―READ‖ button to get the curren setting and aselect the mode which you want, then click
on ―SET‖ button to confirm the setting.The navigation mode configuration can be check
via the state of the LED on PandaⅡmodule,or check on the GCS after the GPS
positioning well.
 After finish the configuration, please click the ”Save” button in page” Param1”
in the tool bar to save the setting.