Owner's manual

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [e-mail]
Page 19
12. Connection Between PandaⅡ And GCS
Software
12.1 Steps Of The Connection And Upload The Map
Step A : Assumption the Autopilot system have installed ,connect to the computer
and power on normally.
Step B : Double click the icon ― ‖ start the software.
Step C : Select the correct COM port (e.g. COM3),baud rate:19200,click on
―Connect‖ button.
Step D : Enter the ID number in the pop-up ID setting dialog box(The default number
of the PandaⅡ is ―00000‖ ),click on ―OK‖ button.
Step E : Choose the save path and rename the file in the pop-up dialog box then
click on ―Save‖ button to save the log file of flying. Connection between
PandaⅡ and GCS finish.
Step F : Click on ―Open‖ button on the GCS select the *. gst files, click on ―Open‖
button uploaded the map to the software(Skill of map making please refer to
the Appendix B ).
Figure Load Interface
1. Select the Pre-made to the map
2. Click ―Open‖