Owner's manual

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [e-mail]
Table Of Content
User Agreement ......................................................................................................................................1
1. PandaⅡAutopilot System Introduction ...........................................................................................2
2. Major Autopilot Components...........................................................................................................3
3. Technical Parameters .....................................................................................................................4
4. PandaⅡ Instructions .....................................................................................................................5
5. Connection Diagram .......................................................................................................................8
6. S1~S8 Servo Interface Connection Instructions ...........................................................................10
7. The Instructions Of Each Modules‘ Connection ............................................................................10
8. The Installation Of Main Module ...................................................................................................13
8.1 PandaⅡ Module Installation ................................................................................................13
8.2 GPS Module Installation .......................................................................................................14
8.3 Power Management Module Installation ...............................................................................14
8.4 Data Radio Module Installation .............................................................................................14
8.5 Airspeed Sensor Module Installation.....................................................................................15
9. PandaⅡ Indicator Light Instruction ..............................................................................................16
10. RC Unit Requires And Setting ......................................................................................................17
11. Parameter Setting Software (GCS)——USB Driver And GCS Software installation .....................18
12. Connection Between PandaⅡ And GCS Software ......................................................................19
12.1 Steps Of The Connection And Upload The Map ...................................................................19
12.2 Steps Of ID Number Reset ...................................................................................................21
13. Parameters Setting Process Of PandaⅡ Autopilot......................................................................23
14. PandaⅡAutopilot System Other Setting .......................................................................................31
14.1 Power Voltage Calibration ....................................................................................................31
14.2 Photograph Control ..............................................................................................................31
14.3 Automatic Take Off ...............................................................................................................32
14.3.1 Automatic Take Off Mode Setting .............................................................................32
14.3.2 Automatic Take Off Parameters Setting ....................................................................33
14.3.3 Process Of Automatic Take Off .................................................................................33
14.4 Automatic Landing................................................................................................................34
14.4.1 Automatic Landing Mode Setting ..............................................................................34
14.4.2 Automatic Landing Achieving ...................................................................................35
14.4.3 Automatic Landing Point Setting ..............................................................................36
14.5 RC Switch (SW2) Setting .....................................................................................................37