Owner manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 38
Flight mission without using Remote Control
Assume you have done all the test work for Panda2.
Now we can do a simple aerial photography mission without using Remote Control.
1.Power on and wait for the GPS positioning success.
2.Connect Panda2 to our GCS software, using aerial photography route planning function
to set a Line Spacing200m,Distance Buffer200m, altitude200m route and upload the route.
Set every 4 seconds to automatic take a photo. Cancel the Route loop function .
3.According to the flight space set the landing point, planning out of the land routes.
4.Open the camera and make sure the camera is ready.
5.Prepare for throwing take off. Click on . Wait the motor reaches maximize
speed, then push the aircraft into the air.
6.Wait the aircraft climb to 100m and circling around the Home point.
7.Through GCS to set , and wait the aircraft automatic climb to 200m.
8.Click on to start automatic navigation flight.
9.Wait the aircraft to fly according to the route you have set, then click on to
start automatic take photo.
10.Wait the aircraft complete the flight mission and cancel the automatic take photo
function.
11.Click on ,and wait the aircraft automatic return to home.
12.Click on ,and wait the aircraft automatic landing, power off and extract the
photos.