Owner manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 35
Auto landing setting and debugging
In order to realize the auto landing function you need to set 2 point to make sure the
lading air route. One is landing point, please click on to set point A .Another
is Home point, please click on to set point B ,The auto landing air route is
A-B, and B is the aircraft landing point. Point C is the automatically generated downward
spiral point during the auto landing procedure. Automatic landing will consists of the following
three stages.
1.Click on to start auto landing, first the aircraft will fly to circling point C.
2. When it reaches point C, it's will auto circling around point C, and gradually decline to 50
meters.
3. The aircraft will continuous to decline the altitude to 25 meters and at the right time to cut
into A-B route.
4. Enter the AB air line and control the altitude as far as possible to make the aircraft landed at
point B, and at the right time to close the throttle, end whole Auto Landing.
Spiraling down points
Spiraling down points
Home point
Landing point