Owner manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 31
10. Set the Home point: After power on,Panda2 will take the GPS first location point as Home Point.
But you also can through button to set the new Home Point.
11. Gyro Initialization: Please click on the ―Gyro Init‖ button to do the gyro reset. Attention: During
the gyro reset, please keep the panda2 static and you can not to do the gyro rest during the flight. It‘s
better to do the gyro reset before each flight.
12. Initialization of the airspeed: Put the aircraft keep static, you can use your hand to cover the port
of the airspeed , and do not let the wind interfere with the airspeed sensor, then click the button
.After that please check whether the airspeed showing on GCS is in the vicinity of 0-3.Due
to the sensor error, there are some tiny airspeed value on the ground is normal.
13. Take off: Now you can take off at ―Stabilized Mode‖ or ―Manual Mode‖.
14. Through the RC stick to trim the plane to level fly. Manually to change the plane roll and pitch,
etc., to observe the plane automatic balance situation. If recover to balance is too quick, don't feel
flexible operation you can reduce corresponding channel control gain; If the pitch, roll and orientation
rapid shaking, or flight speed increases appear sloshing, you need reduce corresponding control
channel gain; If recover to balance is too slow, the poor control ability is require you to increase
control gain.