Owner manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 30
Airspeed indicator and altimeter display value should be 0 or near 0 .Taking the Aircraft roll tilt,
pitch, tilt, and head deflection, and check whether the servo control surface automatic movement is
correct or not, the inspection method, please refer to the description of" Servo Control Reverse
setting".
Attention: If you normal connect the airspeed sensor to Panda2,the speed table(picture
below ) will display the airspeed. And if you do not use the airspeed sensor(Only connect the
GPS to pabda2),then will display GPS speed.
7. Data checking and vibration testing:
First check every flight control data is right or not.
Pushing the throttle ,and check whether the value of the " AHRS ERROR " is increase at each
throttle part. The normal situation is at the value of 0, if the values continue to increase, it shows that
you need to do more damping installation for Panda2 module. If you do not do well job for damping
installation, the aircraft can not take off.
8. Putting the aircraft into the field, and waiting for GPS positioning success. The
GPS red LED will continuous flash after GPS positioning success. At the same time
you can see the icon of the aircraft on the GCS software.
9. Setting a simple routes, for example, you can set a rhombus routes ,its length is about 500 meters ,
the height of Waypoint is 200 meters.