Owner manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 29
1. Assume that flight control system and ground control system connection is complete and right.
2. Turn on your RC, power on your aircraft and ground control station.
3. Open our GCS software，choose the right COM，baud rate 19200，Click on ,input file
name "test", click on ―Save‖, now you should be able to see the flight data like attitude,
altitude ,voltage ,etc. on our GCS software.
4. Please check your RC 3-position switch setting is right and effective or not. First check
―SW2‖,Switch SW2 and make sure you can see the flight mode ―Path NAV‖, ―RTH‖ change on our
GCS software. If the SW2 setting is right, please switch ―SW2‖ to ―NULL‖. Now check the ―SW1‖.
Switch SW1 and make sure you can see the flight mode ―RC‖, ―RPV‖, ―Aerobatics‖ change on our
GCS software.
5. Switch ―SW2‖ to ―NULL‖ and switch ―SW1‖to ―Manual mode‖. Use your RC sticks to control the
aircraft servos surface to see the movement is right or not.
6. To Check the servo control surface automatic movement and setting install direction, also the
airspeed and altimeter, First, you should switch"SW2" to "NULL" mode, then switch "SW1" to the "
Stabilized Mode ".
Taking the Aircraft roll tilt and pitch tilt, and checking whether the GCS attitude table shows the
attitude is correct or not if not, you need to re-set the" Inst Setting " .
First flight test