Owner manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 23
Connect Panda2 to our GCS software
When you finish the flight control system installation and power on the whole system. Please
choose the right COM"X"(Like:COM1),baud rate:19200 and click on "Connect" button, this time
will pop-up a dialog, ask you to enter a file name which used to keep records of the flight
trajectory. For example we input the file name "test", click on for sure, the trajectory will be saved
into "test.log" file. And you should be able to see the flight data like attitude, altitude ,voltage, etc.
on the left side of our GCS software.
Attention:Panda2 default control mode is data radio(RC receiver is connect to Remote
Adaptor and on the ground),through data radio to control the aircraft. If you use RC control
mode(RC receiver is directly connect to Panda2),Please through our GCS software to do
the control mode change.
DRRC(Default) RC (RC receiver is connected to Panda2)