Owner manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 19
RC setting、SW1&SW2 channel setting
 Panda2 requires a minimum of 6-channel RC receiver.4 Receiver channels are used for
aileron (channel 1), elevator (channel 2) ，throttle (channel 3) and rudder (channel 4) signal
output. 2 free Receiver channels are required to control the Panda2 Flight Modes (a
3-position switch or dial knob, ‖SW1‖) and Autopilot Mode (a 3-position switch or dial
knob, ‖SW2‖).
 RC mode Setting of your controller has to be fixed wing mode and cancel all mix control
setting.
 Panda2 need two 3-position-switch to control the flight mode. One SW1 used for setting
manual mode, stabilized mode and 3D mode, another one SW2 used for setting Auto
Return To Launch Mode and Waypoint Navigation Flight Mode(default) or Auto Circling
Mode and Fixed altitude & Heading lock Mode(Need to setup through the setting
software).
 After set up switch mode, you can through switch to the corresponding position then
according to LED flashing situation to confirm whether the setting is correct or not. the
details please see"Pnada2 indicator light instruction"
 SW1&SW2 default setting:
SW1
SW2
Manual Mode
Waypoint Navigation Mode
Stabilized Mode
NULL
3D Mode
Return To Launch Mode