Owner manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 17
Airspeed Sensor module installation
 The airspeed sensor need to pull ahead the front of the pneumatic opening and in the line
with the direction of flight. You can install the Airspeed sensor to the wing or in the front of
the nose, do not block the front of the air inlet , we can use the glue to fix the airspeed
sensor. Note: Make sure that after installation, the fuselage in flight airflow can not interfere
with air intakes.
 Attention: Panda2 firmware V1.12 and above added support for new airspeed sensor. If
you use our new airspeed sensor,please upgrade Panda2 firmware to V1.12 and above.
Data Radio module installation
 The Data Radio module should placed away from the GPS module , Panda2 module and the
servos as far as possible, in order to avoid the disruption of these devices. The Data Radio
antenna should be vertically up or down when you install it .
 Certain frequency bands from the Data Radio can interfere with servos due to
electromagnetic emission. To resolve this issue either avoid placing the Data Radio
transmitter close to sensitive components or use a magnetic core (as shown below) to
reduce the interference.