Manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [e-mail]
Page 47
While flying in a straight line and having no input through the transmitter sticks.
Please through the to record servo neutral.
( 16 ) Target speed setting (Default setting is 60km/h).The flight speed is very important, you
can not optional Settings. The speed must can keep aircraft keep normal flight. We suggest not
increase the settings too high, it may cause very unusual flying behavior and may result in damage of
your aircraft due to excessive throttling. 
software and assess the flight cruising speed to set the target speed.
Through---  please do
not forget to click on to save the setting to our PandaⅡ
( 17 ) Switch SW2 to Return To Launch (RTL)mode to watch the aircraft automated return to
home or not. Upon reaching the home point it will automatically engage auto circling, while it waits for
your further instructions.
( 18) After Return To Launch test, please switch SW2 to Path Navigation mode to watch the
aircraft according to preset route fly or not.
( 19 ) Take off and finish the first flight test.
14. Introduction to other functions and Settings
14.1 Operation for the click point flight
Switch .
Click on the button then you just need to click the flight target you want in the map.
The aircraft will fly to the target point and circling around it waiting for your next instruction.
14.2 Route Loop function
The default path navigation in PandaⅡ is auto repeat .when the plane fly over the last waypoint
it will fly back to the first waypoint. You can cancel this default value via the GCS software
button, then the plane will not fly back, just circle in the last waypoint.
14.3 PID parameters instruction and adjust
The PID parameters adjust require you have professional knowledge.