Manual

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [e-mail]
Page 22
Connection ID number
Firmware of PandaⅡ V1.2 or above version increased the ID number matching
function .Users can set the ID number of the PandaⅡ by oneself , only when enter the correct ID
number on the GCS ,it can establish connection with PandaⅡ .This function can effectively avoid the
problem which interference the control of the Padan2 because using the data radio in the same
frequency .
Version below PandaⅡ Firmware V1.2 or other products which don’t need to set the ID
number (such as : FY-DOS, FY-41AP),Please enter “00000” in the ID setting dialog box.
Setting ID number

，you
can only connect the UART port of the PandaⅡ module to the computer via the USB cable . Or you
can doing the ID number matching operation under option 1 and option 2 .
But you have to ensure that install the jumper to P1 ,P2 when power on to execute the bounding
operation .
Install the jumper to P1,P2 port ,then power on to PandaⅡ.